FO: Leaf Cozy

With so little of my bulky yarn in mineral heather left, I thought I better measure it before committing to a pattern. 18.01 meters exactly. I decided to keep with the leaf theme I’ve got going with the blue leaf headband and the lacefield mitts and finish off the ball with a leaf cozy:


Now I knew this project would be cutting it close. But I stuck to the pattern and began the leaves. Each one requires you to pick up stitches along the side of the previous on, with the idea that it will eventually be seamed back to itself. Starting the third leaf, my supply of yarn was looking dangerously low…


It was clear I didn’t have enough to make a full sized fourth leaf, but I wasn’t about to turn back. In order for the pattern to work there must be an even number of leaves. For the fourth one, I picked up five stitches (instead of the required nine) and only did three increase rows instead of four. Here it is as I was decreasing – look how little yarn I have left!IMG_20141104_124215


That was a close one! Literally mere centimetres left. After all the loose pieces were woven in (but before blocking, so it still looks a little wonky) I had this: IMG_20141105_082605

Luckily I left a 4″ tail at the beginning for seaming as instructed. Once seamed up, I took the opportunity presented by the smaller leaf to seam it to both the first leaf and part of the second leaf, making the cozy decidedly asymmetrical. I could go back, eliminate the final increase and decrease on each leaf and then all four might be more even, but I kind of like that it’s asymmetrical. I think it works.


I blocked this guy in two stages. First, soaking wet in cold water, covered in a towel and flattened by a few textbooks. Then, when it was still slightly damp, I shaped it around a travel mug and left it to finish drying, so that it was the exact shape I wanted it to be. Because my gauge was larger than the pattern specified – due to using bulky yarn instead of the called for worsted weight – the final circumference is correct for a standard (large) cup of tea, despite the smaller final leaf.

Yarn: Knit Picks Wool of the Andes Superwash Bulky in Mineral Heather, exactly 18.01 meters.

Pattern: Leaf Cup Cuddler by Knit ‘n Kaboodle. A+ pattern. The picture tutorial on how to pick up stitches between each leaf was very clear and saved what I’m sure would have been much frustration.

Needles: 6 mm, worked flat.

Skills Required: Knit, Purl, cast-on, bind-off, yo, ssk, k2tog, picking up stitches. Moderate difficulty, but very well presented instructions.

You may also like

Leave a Reply

Your email address will not be published. Required fields are marked *